PA 12 nylon

The workhorse nylon for functional parts. Strong, stiff, chemically resistant and close to isotropic, so parts behave the same in every direction.

Typical properties

Tensile strength≈ 48 MPa
Elongation at break≈ 20%
Heat deflection (0.45 MPa)≈ 175 °C
Density of parts1.01 g/cm³

Values are typical for HP 3D High Reusability PA 12 and vary with part design and orientation.

Good for

  • Housings and enclosures
  • Brackets and mounts
  • Jigs and fixtures
  • Drone airframe parts

Why PA 12

  • Tough and slightly flexible, so clips and snap-fits bend instead of breaking.
  • Resists oils, greases, fuels and most chemicals.
  • Low moisture uptake, so parts stay dimensionally stable.
  • Light: parts weigh about the same as water for their volume.

Design and finishing

Keep walls at 1 mm or more and leave 0.6 to 0.7 mm between parts printed together. The full list is in our HP MJF design guidelines. PA 12 can be left raw grey, graphite blasted to a darker grey, dyed black or painted.

Made at our Ibrahimpatnam, Hyderabad unit. Upload your files for a quote.

PA 12 questions

Is PA 12 the same as nylon 12?

Yes. PA 12 (polyamide 12) is nylon 12, the most common material for HP Multi Jet Fusion.

What temperature can PA 12 parts take?

Heat deflection is about 175 °C at 0.45 MPa, so parts work well under the bonnet, near motors and in warm enclosures.

Can PA 12 parts be coloured?

Yes. Parts can be dyed black or painted in any colour.

Ready to print?

Upload your CAD files and get a quote within hours.