Designing parts for HP Multi Jet Fusion: a practical checklist

Wall thickness, clearances, holes and text: the rules that decide whether an MJF part comes out right the first time.

By Pranava Fusion engineering team · · 1 min read · MJF, Design for AM

Multi Jet Fusion is forgiving compared with most 3D printing processes. There are no support structures, so overhangs and internal channels print without trouble. A few design rules still decide whether a part comes out right the first time.

Wall thickness

Keep walls at 1 mm or more. Thin walls print, but they warp and break easily during depowdering. For large flat areas, go to 2–3 mm or add ribs.

Clearances for moving parts

Assemblies printed in one piece need a gap between surfaces. Use 0.5 mm as a minimum and 0.7 mm if the parts must move freely without post-processing.

Holes and threads

Small holes close up slightly. Design holes 0.1–0.2 mm oversize, or drill and ream after printing when the fit matters. For threads that will be assembled more than a few times, use brass heat-set inserts instead of printed threads.

Hollow parts

Solid blocks waste powder and time. Hollow the part and leave two escape holes of at least 5 mm so unfused powder can be removed.

Text and fine features

Embossed or engraved text should be at least 1 mm deep and 6 pt high to stay readable.

Send us the drawing too

If some dimensions are critical, send a 2D drawing with tolerances along with the STEP file. We orient the part in the build to protect those features and inspect them before dispatch.

Ready to print?

Upload your CAD files and get a quote within hours.